Here’s the next generation of roof tents from South Africa, with a tough as nails aluminium construction that is going to blow your mind!

The new, third generation Expedition 3 Rooftop Tent from Alucab (distributed by is one of the best hard-shell tents on the market. Made entirely of aluminium, it carries the heaviest load and is assembled very quickly.  The newest version is slightly taller than past generations and has a sleeker look with angled sides at the front. It is more elegant compared to other Aluminium tents. Its new shape also makes it more aerodynamic and more wind resistant than previous generations. This improves the ability to drive at higher speeds and reduces wind noise and fuel consumption.

The already stable Aluminium substructures are reinforced with four longitudinal beams. Thus reducing distortion and eliminating the possibility of fractures. The roof is reinforced by two built-in cross profiles and can be used to transport cargo, to install a solar panel or use as a look-out point.


To open the tent, simply unlock the two rear clasps. Lift the end of the roof slightly, and the gas-pressure springs will release the tent. Three entrances have mosquito nets, and the rear entrance has a sloped roof for protection against sun and rain. These are kept open by two quick-release tension rods. The tent overlaps down slightly over the entrances. This way, the zipper can be opened from the top without letting in any rain. The upper shell, which is wider than the tent, is additional protection against rain.

An elastic band pulls the rooftop tent inwards to close it, which also prevents the material from getting jammed between the shells or gas-pressure springs. Because these are also connected on the outside, there is no restriction on the mattress, no clamping of the material or bedding when closing, and condensation at the gas-pressure springs is not a problem. If necessary, the tent can be secured against unauthorised opening by one or two padlocks.


The floor and the roof are both insulated with closed-cell polyethene foam. This provides good protection against cold and heat. This increases comfort and reduces condensation in the tent. Additionally, the Rooftop Tent is covered with a multi-layered, stitched fabric. The 400g/m² tent is waterproof and UV-resistant. The rip-stop canvas stops cuts from further tearing. All seams are reinforced and waterproofed.

For a more comfortable sleep, a 75mm thick, high-density foam mattress is provided. The cover can be easily detached by a zipper. The roof has several little pockets for storing smaller items. Two permanently installed LED reading lights with flexible necks  provide ample lighting.


The Alu-Cab Generation 3 Expedition Rooftop Tent not only fits perfectly to Alu-Cab canopies, but it is also the first choice of those who want to leave their rooftop tent on the vehicle permanently. Aluminium is durable, resistant to corrosion and does not age when exposed to UV light. In addition, Aluminium is not sensitive to temperature fluctuations and rocking leads to scratches or dents at most, but unlike in the case of Fibreglass tents, nothing will puncture the tent shell. For those who like to attach many accessories to their tent, an aluminium rooftop tent is also the best choice. The mounting of holders for headlights, high lifts, shovels, antennas, canisters, solar panels, etc. is possible and easy. Athletes can easily transport kayaks, bicycles or skis on the roof. An additional storage box can also be attached.


The tent is 2.3m long and 1.4m wide. Closed, it is 210mm high in the front and 250mm in the back. The inner dimensions of the tent are 2.1 x 1.3m. The height at the back is 1.45m. The weight of the tent (including the mattress) is about 78kg. The Rooftop Tent is available in standard silver-grey and black.  On special order also available in any RAL colour. The aluminium roof tent is priced at 3.800Euros, that is £3.350 including VAT.

More info: